pH water Power/ Lignum Plus/ ph Help
(SKU P05)
ADJUVANT
WATER CONDITIONER
Optimizes spray efficiency by acidifying and softening water while reducing droplet bounce
Built-in pH indicator for easy visual monitoring of water acidity
Prevents sprayer build up while eliminating foam for efficient application
sulphuric acid
aliphatic acid
ethoxylated alcohol and other ingredients
SHAKE WELL BEFORE USE!
Add 9/10 of the required volume of water to the sprayer tank. With mixing on, add the calculated amount of the product until the tank mixture turns brick-red. Add plant protection products, micronutrient fertilizers, adjuvants in accordance with the manufacturer's recommendations and the remaining amount of water (1/10 of the total amount). Mix thoroughly and spray the solution within 24 hours of preparation.
SPECIAL CASE. When using boron fertilizers based on boron ethanolamine, dissolve it first, then condition the resulting tank mixture with the product.
NOTE: If in doubt, it is recommended to check the compatibility of all mixed products (for residues, layering, etc.) in advance in a small container (min. 500 ml capacity). When mixing, follow the products’ proportions.
Keep the product in its original packaging in a well ventilated area, no lower than 0°C and no more than +40°C temperature, out of the reach of children, away from food, drink, animal feed, electricity, heat sources and direct sunlight. Product may be stored for up to 24 months.
Usage rates
Can be used with any officially registered plant protection products and foliar micronutrient fertilizers.
Note. Read the labels of plant protection products carefully and make sure there are no restrictions on the use of additives.
Note. The specific application rate may differ from the table as it depends on water salinity, suspended solids and specific tank mix agrochemical products which significantly affect the pH value (e.g. boron ethanolamine a.i. in the case of boron fertilizers). FOCUS ON VISUAL COLOR CHANGES.
Application rates.
Measure the water pH and select the appropriate application rate from the table below:
Initial water pH
pH WATER POWER average application rate of water to adjust pH to 5.5, ml/100 L
9.0
100
8.5
90
8.0
80
7.5
70
7.0
60
6.5
50
6.0
40
Other products in this category
Lignum
Application enhancers
MORE >
